4040 T Slot 6063 Sand Blasting Anodized Aluminum Profiles

1. Pearl cotton foam for each profile;

2. Wrap with shrink film exterior;

3. Packed according to customer request.

Providing colorful products with various mechanical

performances to adapt all kinds of architectural styles

Recovery of profiles that are out of standard

• Recovery of second selection materials.
• Homogenization of surfaces.
• Elimination of superficial stripes because of a failure of the extrusion mold or defects caused during the handling of the profiles.
• Elimination of superficial stains
• Low operative cost
  • 1 Kilos of consumption of stainless shot per ton of anodized profile.
  • Depending on the temperature of the bath and the level of concentration of caustic soda used in the process, the time of the alkaline bath can be reduced to 85 %.
  • Less chemical material used (caustic soda and sulfuric acid).
  • Less manpower.
  • Higher lifetime of extrusion mold.
  • The equipment is easy to operate and does not require specialized personnel.
  •  
  • Ecological Process
    • Decrease of cost of effluents treatment by using zero chemical products.
    • Decrease of risk to the personnel because of the handling of less chemical materials dangerous to health.
    • Decrease of damage in facilities or buildings due to vapors produced during the chemical scaling.

• 1. It does not cause structural or corateral damage on the physical structure.
  2. Possibility of controlling the final roughness of the profile according to the results wished.

• General Characteristics of the shot blasting equipment for aluminum profiles.

• Proper distribution of the turbines achieving an excellent shot blasting coverage.

• Possibility of decreasing or increasing the speed of impact of the abrasive in a way

That allows adjusting conveniently the roughness obtained in the process.

• Automatic opening and closing of the shot valves to avoid the unnecessary wear of

the equipment.

• Intermediate cyclone to perform a correct separation of abrasive/dust avoiding that

good abrasive is withdrawn from the equipment unnecessarily.

• Internal covering of working chamber made of cast material of high resistance to wear by abrasion.

• Roller conveyor that allows processing several profiles simultaneously.

• Autoloader of shot to keep the mixture of shot in the system constant.

• Automatic process of shot blasting does not require skilled manpower.

• The dimensions for maximum passage of parts and production speed can be adapted to the requirement of the customer.

• Blast cleaning is a process of non-polluting mechanical scaling therefore it is not necessary to use equipment to regenerate additional waste like effluent treatment plants.